Powermatic DS20 User Manual

Operating Instructions and Parts Manual 20-inch Disc Sander Model DS20 Three Phase model shown WALTER MEIER (Manufacturing) Inc. 427 New San

10Adjustments Table Movement The work table (A, Figure 5) can be tilted 30 degrees forward and 45 degrees backward. 1. Loosen the handle (B, Figure

11Miter Gauge The miter gauge is equipped with individually adjustable index stops at 90 degrees and 45 degrees right and left. The index stops can b

12Forward-Reverse The three phase model of the DS20 has a Forward-Reverse switch (Figure 11). When changing direction with the Forward-Reverse switch

13Troubleshooting Trouble Probable Cause Remedy Machine will not start/restart or repeatedly trips circuit breakers or blows fuses.

14Trouble Probable Cause Remedy Machine vibrates excessively. Sander base not level with floor. Shim if necessary. Not secured to the floor. Use lag

15Parts List: DS20 Disc Sander Index No. Part No. Description Size Qty 1 ... 6295560 ...Base ...

16Index No. Part No. Description Size Qty 55 ... 6295615 ...Phillip Head Screw...1/4&

17Exploded View: DS20 Disc Sander

18Parts List: Brake Assembly Index No. Part No. Description Size Qty ... DS20-200 ...Brake Assembly (includes index #1

19Electrical Connections

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au

3 Table of Contents Warranty and Service...

4 Warni ng 1. Read and understand the entire owner’s manual before attempting assembly or operation. 2. Read and understand the warnings posted on

5 21. Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious

6 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a Powermatic

7 Installation Tools required for assembly: 6mm hex key (“Allen wrench”) Exposed metal areas of the Disc Sander have been factory coated with a prote

8 Dust Collection The use of a dust collection system with the Disc Sander is strongly recommended. It will maintain shop cleanliness, and help preve

9 The three phase Band Saw may be converted to 460 volt operation. Re-connect the motor leads according to the diagram inside the motor junction box.