Powermatic 1791228K User Manual download pdf (Page 15)

15

Mounting Table Insert

1. Place the table insert into the table opening.

With a straight edge, check to see if the

insert is level with the surface of the table.

See Figure 22.

2. If the insert is not level, correct it by using

the straight edge and turning the four set

screws in or out until the insert is flush with

the table.

Mounting Extension Wings

TIP: Use WD-40® to clean table edges.

1. Have an assistant hold the wing in place

while the three 7/16-14 x 1-1/4 screws are

inserted with the 7/16 lock washers. Do not

tighten screws completely.

(NOTE: If an assistant is not available, hold

the wing in vertical position and insert one

7/16-14 x 1-1/4 screw and one 7/16 lock

washer into the middle hole. See Figure 23.

Finger tighten this screw to the saw's table,

then pivot the wing to horizontal position,

and install the other two screws finger tight.)

2. The front edge of extension wing is the most

critical and must be flush with the front edge

of saw table. If necessary, tap the edges of

the wing with a rubber mallet (or hammer

and block of wood) until the front edge of

wing lines up with edge of table.

3. Place a straight edge across both the

extension wing and table top. Level the

surface of the wing with the table top, then

tighten the middle screw.

4. Repeat step 4 at the front and back of the

extension wing. Tighten each screw as that

part of the wing comes flush with the table.

5. Repeat process for other extension wing.

Mounting Rails and Accu-Fence®

With the extension wings properly aligned, the

rail and fence assembly can now be mounted to

the saw. Consult the separate Accu-Fence

manual for instructions.

Optional Wood Extension Table

For instructions on mounting the accessory

wood extension table, or router table, consult

your Accu-Fence® manual.

Figure 22

Figure 23

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comments to this Manuals

No comments