Powermatic PJ1696 User Manual download pdf (Page 11)

11

START / STOP SWITCH

The arm (E-Fig. 9) on which the pushbutton

switch is located is shipped in the down

position. The screws (F-Fig. 9) should be

loosened with a 10mm hex wrench and the

arm pivoted to upright position. Re-tighten

screws.

ELECTRICAL CONNECTION

IMPORTANT: Make sure the electrical

characteristics are the same between the

motor nameplate and the power source, and

make sure the circuit on which the jointer will

be used is properly fused and that the wire

size is correct.

WARNING: Electrical connections

must be made by a qualified

electrician. The machine must be

properly grounded to help avoid

electric shock and possible death.

1. Connect wires both to junction box and

power source (see electrical schematic, page

34). The green wire (ground) must be

properly grounded.

2. After wiring is complete, turn motor on

momentarily to check for proper direction of

rotation (cutterhead should rotate toward

infeed table). If rotation is in the wrong

direction, disconnect machine and switch any

two of the hot leads. Reconnect power and

confirm proper rotation.

3. Run the machine without cutting for a

short time to check that all powered functions

are operating properly.

ADJUSTMENTS

Tools required

17mm & 19mm spanner

DRIVE BELT

Remove the three crown nuts and washers

(A-Fig. 10) on the belt cover with a 17mm

spanner, and remove the cover. Use a

19mm spanner to adjust the nuts in the motor

support (B-Fig. 11).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments