Powermatic PJ1696 User Manual download pdf (Page 13)

13

3. Lower the outfeed table until the straight

edge contacts a knife. Rock the

cutterhead slightly to make sure the apex

of the knife is contacting the straight

edge. Lock the outfeed table at that

setting.

After the outfeed table has been set at the

correct height, it should not be changed

except for special operations or after

replacing knives.

Examples of incorrect settings:

If the outfeed table is too high, the finished

surface of the workpiece will be curved,

shown in Figure 14.

If the outfeed table is too low, the work will be

gouged at the end of the cut, shown in Figure

15.

As a final check of the outfeed table

adjustment, run a piece of wood slowly over

the knives for 6 to 8 inches; it should rest

firmly on both tables, as shown in Figure 16,

with no open space under the finished cut.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments