Powermatic 60HH User Manual download pdf (Page 20)

20

Fence Stops

See Figure 29.

Periodically check the 90 degree and 45 degree

tilt accuracy of the fence with an angle

measuring device, such as an adjustable square

or machinist's protractor. If adjustments are

necessary, proceed as follows:

90-degree stop:

1. The 90-degree stop is controlled by the

screw (E, Figure 29).

2. Loosen the locking handle (C) and the hex

nut on the screw (F).

3. Set a square on the table and against the

fence, and rotate the handwheel (G) to

move the fence flush against the square.

Rotate the screw (E) until it contacts the

stop block (D).

4. Tighten the hex nut (F) and the locking

handle (C).

45 degree forward stop:

1. The 45 degree forward stop is controlled by

a screw (H, Figure 29) that is located at the

bottom end of the link bar.

2. Loosen the locking handle (C) and the hex

nut on the screw (H).

3. Set a 45 degree measuring device on the

table and against the fence, and tilt the

fence until it is flush against the device, and

therefore at a 45 degree angle.

4. Rotate the screw (H) until it contacts the

casting below it.

5. Tighten hex nut (H) and locking handle (C).

45 degree back stop:

1. Flip the stop block (D, Figure 29) out of the

way.

2. The 45 degree back stop is controlled by the

screw (J).

3. Loosen the locking handle (C) and the hex

nut on the screw (K).

4. Use an angle measuring device set at 45

degrees beyond the right angle (a total of

135 degrees) and place it on the table and

against the fence. Tilt the fence until it is

flush with the protractor.

5. Rotate the screw (J) to the proper height.

6. Tighten hex nut (K) and locking handle (C).

Figure 28

Figure 29

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Comments to this Manuals

No comments