Powermatic 60HH User Manual download pdf (Page 9)

Assembly

Exposed metal surfaces, such as the table and

fence, have been given a protective coating at

the factory. This coating should be removed with

a soft cloth and solvent (such as mineral spirits)

once the machine has been assembled. Do not

use an abrasive pad as it may scratch the

exposed surfaces.

NOTE: If any procedure described herein needs

further clarification, consult the assembly

drawings at the back of this manual.

Tools required for assembly:

3mm and 6mm hex (Allen) wrenches

17mm, 14mm, (two)12mm open-end wrenches

screwdriver

Assembling Jointer to Stand

Refer to Figure 6.

1. Locate the stand on a level floor. If desired,

the stand can be secured to the floor using

two anchor bolts (not provided) through the

holes inside the bottom of the stand. If using

an optional mobile base, be sure to lock the

wheels before assembling, operating or

adjusting the jointer.

The jointer is very heavy.

Exercise proper caution when lifting it.

2. Use a hoist or forklift with straps, to lift the

jointer onto the stand. (The front of the

jointer should face the same direction as

curved front of the stand.)

3. Shift the jointer atop the stand until the 3-

hole pattern aligns in jointer base and stand.

4. Secure jointer base to stand with three 3/8”-

16 x 2-3/8” carriage bolts (AA), six 3/8” flat

washers (BB), three 3/8” lock washers (CC)

and three 3/8” hex nuts (DD). (Note: On the

left hand hole, it may be easier to insert the

carriage bolt from beneath as shown.) Only

finger tighten bolts until all three are

properly inserted; then fully tighten the hex

nuts with a 14mm wrench and a 17mm

wrench on the heads of the screws.

Cutterhead Guard

Place the post of the cutterhead guard (J, Figure

6) into the hole on the rabbeting ledge as

shown. (Always use caution when working

near the cutterhead knives!) Rotate the

locking handle until it tightens into the groove on

the cutterhead guard post.

Figure 6

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Comments to this Manuals

No comments

Powermatic 60HH User Manual Page 9

Comments to this Manuals

Related products and manuals for Unknown Powermatic 60HH