Powermatic 66 User Manual download pdf (Page 9)

9

3. Level the extension wing with the saw table

across its entire width, using a straight edge

and hammer with block of wood (or rubber

hammer). See Figure 5. As each area of the

wing becomes flush with the table, tighten

the screw under that area. Continue until all

three screws are fully tightened.

4. Repeat for the other extension wing.

Installing Blade

NOTE: The blade must be mounted first before

rails can be adjusted.

To install or replace a blade, proceed as follows:

Use care when working with

or around sharp saw blade.

1. Disconnect machine from power source.

2. Remove table insert, then remove arbor nut

and collar.

3. Install blade, making sure the cutting teeth

at the top of the blade point toward the front

of the saw.

4. Slide the collar on to the arbor and start the

arbor nut on the threads. (NOTE: Right-

hand threads; turn clockwise to tighten.)

Snug the arbor nut against the collar and

blade with the provided arbor wrench, while

holding blade with thumb and finger tips.

5. Wedge a block of wood between the blade

and table to prevent blade rotation, then

tighten the arbor nut securely with the arbor

wrench. See Figure 6.

Mounting Rails and Accu-Fence

With the extension wings properly aligned, the

rail and fence assembly can now be mounted to

the saw. Consult the separate Accu-Fence

manual for instructions.

Optional Wood Extension Table

For instructions on mounting the accessory

wood extension table, or router table, consult

your Accu-Fence

manual.

Splitter and Guard Assembly

1. Insert the grooved end of the splitter support

shaft through slot in rear of saw and into

hole in trunnion. See Figure 7. Make sure

the square head setscrew (A, Figure 8) is

backed out enough to allow easy insertion

of the splitter support shaft.

Figure 5

Figure 6

Figure 7

Figure 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comments to this Manuals

No comments