Powermatic Saw PWBS14 User Manual download pdf (Page 12)

12

3. With the aid of a second person, lift the saw

body out of the shipping container and place

on top of the stand. Be sure front of saw (with

Powermatic logo) faces curved stand front.

WARNING

Saw body is heavy! Use caution when lifting

and stabilize until firmly attached to the

stand! Failure to comply may cause

serious injury!

4. Line up holes in the saw body with holes in

the top of the stand. Fasten saw body to the

stand with four M8 x 40 hex cap screws, eight

M8 washers, four M8 lock washers, and four

M8 hex nuts (Fig. 2)

5. Push motor cord and strain relief plate

through the opening in the side of the stand.

Fasten the strain relief plate to the stand with

two M5 x 12 pan head screws as shown in

Fig. 3.

6. Connect the plugs of the switch cord and

motor cord (Fig. 3). Do not connect

machine to power source during

assembly.

7. Check the alignment of the pulleys by placing

a straight edge against the flat sides of the

motor and wheel pulleys (Fig. 3a). If the

pulleys lie in a straight plane (Fig. 3b) they

are aligned. If they do not lie in a straight

plane, loosen the set screw on one of the

pulleys and shift the pulley in or out until both

pulleys lie in a straight plane. Tighten set

screws.

8. Open the lower door, and place the v-belt

around the motor pulley and the wheel pulley

(see Fig. 3a).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments