Powermatic Saw PWBS14 User Manual download pdf (Page 14)

14

13. To mount the main table, remove pin and

insert from the table (Fig. 8).

14. Rotate the table so that the saw blade will

slide through the slot in the table. Then orient

the table so the screws will slide into the holes

on the trunnion support. Attach lock knobs to

these screws (Fig. 7).

15. Replace pin and insert (Fig. 8).

16. Loosen lock knobs on the main table and tilt

the main table out of the way. Mount the

extension table (Fig. 9) with four M8 x 65

socket head cap screws through the spacers

(A, Fig. 9). Insert four M6 x 25 socket head

cap screws (B, Fig. 9) with flat washers and

lock washers through the plate and into

bottom of extension table. Insert four set

screws (C, Fig. 9) with hex nuts into outer

holes.

17. Tilt the main table back to level position. The

extension table should be an appropriate

distance from the main table to prevent

interfering with the tilting of the main table.

Loosen the four hex cap screws (B, Fig. 9) to

adjust the gap between the extension table

and the main table.This gap can be properly

set by using the L-spacers (Fig. 9a). Place the

L-spacers between the tables as shown, and

push the extension table toward the main

table as far as it will go. Tighten the hex cap

screws (B, Fig. 9) and remove the L-spacers.

18. The extension table must also be leveled with

the main table. Place a straight edge (Fig. 9a)

across both tables. To raise or lower the

height of the extension table, loosen the hex

nuts and turn the set screws (C, Fig. 9).

NOTE: Before leveling the extension table,

the 90-degree stop of the main table should

be checked and adjusted if necessary. See

page 19.

19. When finished leveling the extension table,

re-tighten hex nuts and set screws (C, Fig. 9).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments