Powermatic Saw PWBS14 User Manual download pdf (Page 20)

5. Loosen jam nut (C, Fig. 23) and turn table

stop (B, Fig. 23) left or right to raise or lower

the stop. Tighten jam nut to hold table stop in

place.

6. Unlock the table and tilt it back on to the table

stop to confirm table is 90 degrees to the

blade. Repeat this process as necessary until

table is 90 degrees to the blade.

7. If necessary, adjust pointer (D, Fig. 23) to

zero.

NOTE: After adjusting the 90-degree stop, it may

be necessary to re-set the extension table so it is

level with the main table.

Changing Blades

WARNING

Blade teeth are sharp! Use care when handling

the saw blade.

Failure to comply may cause serious injury!

1. Disconnect machine from power source.

2. Loosen blade tension with the blade tension

lever. Push the tension lever up slightly, then

out, and pull it down toward the table, as

shown in Fig. 24.

3. Remove the table insert and the table pin.

4. Open both wheel guards.

5. Remove the blade from between upper and

lower blade guides. Remove blade from

upper and lower wheels. Turn blade to direct

it through the slot in table.

6. Guide new blade through table slot. Place

blade in upper and lower blade guides. Note:

Make sure blade teeth point down toward the

table.

7. Place blade so it lies on the center of both

upper and lower wheels.

8. Replace table insert and table pin, and raise

the blade tension lever (Fig. 24) to tighten the

belt again.

9. Tension and track blade before operating

saw. See "Adjusting Blade Tension" and

"Adjusting Blade Tracking".

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

No comments

Powermatic Saw PWBS14 User Manual Page 20