Powermatic TS29 User Manual download pdf (Page 21)

Trouble-Shooting for Model TS29 Shaper

PROBLEM POSSIBLE CAUSE SOLUTION [with page #]

Machine will not start. 1. Faulty switch. 1. Replace switch.

2. Cord damaged. 2. Have cord replaced by authorized

service person.

3. Not connected to power source. 3. Check connection.

4. Connected to wrong voltage. 4. Check voltage.

5. Fuse blown or circuit breaker tripped 5. Replace fuse, reset breaker.

at incoming power source.

Overload kicks out 1. Extension cord too light or too long. 1. Replace with adequate size cord.

frequently. 2. Feeding stock too fast. 2. Feed stock more slowly.

3. Cutter is dull or has gum on it. 3. Clean or replace cutter.

Tool does not come up 1. Extension cord too light or too long. 1. Replace with adequate size cord.

to speed. 2. Low current. 2. Contact local electric company.

3. Motor not wired for correct voltage. 3. Refer to motor nameplate for correct

wiring.

4. Spindle is locked. 4. Release spindle lock knob.

Machine makes 1. Dull cutter. 1. Replace cutter. [11]

unsatisfactory cuts. 2. Gum or pitch on cutter. 2. Remove cutter and clean with

turpentine and steel wool.

3. Gum or pitch on table causing erratic 3. Clean table with turpentine and

feed. steel wool.

4. Feeding work in wrong direction. 4. Feed work against cutter rotation. [5]

Stock burns. 1. Dull cutter. 1. Sharpen by honing on flat side.

2. Cutter too deep. 2. On hardwoods take light cuts; attain

full depth of cut with several passes.

3. Forcing work. 3. Feed slowly and steadily.

Machine vibrates 1. Damaged tool. 1. Replace tool.

excessively. 2. Stand or bench on uneven floor. 2. Reposition on flat, level surface.

3. Bad v-belt. 3. Replace belt.

4. V-belt not tensioned correctly. 4. Adjust belt tension. [15]

5. Bent pulley. 5. Replace pulley.

6. Improper motor mounting. 6. Check and adjust motor mounting.

Edge splits off on Characteristic of cut. 1. Make cross-grain cuts first then finish

cross-grain cut. with grain.

2. Use scrap block to support at end of

cut.

Raised areas on shaped Variation in pressure which holds work 1. Keep work firmly against fence or

edge. against cutter. collars throughout pass.

2. Use hold-downs or stock feeder. [13]

Work pulled from hand No support. 1. Use mitre gauge with clamp or hold-

of cut down to start cut when shaping free-

hand; hold work firmly against fence.

2. Adjust the tension of spring plate.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Comments to this Manuals

No comments

Powermatic TS29 User Manual Page 21

Comments to this Manuals

Related products and manuals for Power tools Powermatic TS29