Powermatic 66 User Manual download pdf (Page 10)

10

2. With a 3/8" wrench, reach through the motor

opening in the stand and tighten the square

head setscrew (A, Figure 8) into the groove

of the shaft. (NOTE: The groove will be in

the proper position if the end of the shaft is

made flush with the opposite side of the

trunnion hole.) Then tighten the hex nut (B,

Figure 8) up against the trunnion.

3. The upright member of the rear splitter

support (C, Figure 9) must be oriented

toward the right of the shaft, as observed

from the rear of the saw.

4. Mount the splitter assembly to the two

adjusting screws. See Figure 9. Place the

two flanges of the splitter assembly onto the

s

crews as shown. Snug the screws. (NOTE:

Make sure the front shield (D, Figure 9)

faces in toward the blade)

5. The splitter and guard assembly must be

aligned with the blade before operating the

saw. Adjust the splitter according to the

directions on page 13, "Splitter Alignment."

Motor Cover

1. Locate the two 1/4-20 self tapping sheet

metal screws and install them in the

punched holes on the saw cabinet. Do not

screw down all the way, but leave the heads

about 1/4" from the surface. See Figure 10.

2. Lift the motor cover over these screws with

the cover's bottom lip inside the saw's

cabinet.

3. Tighten the two screws.

Grounding Instructions

Electrical connections must

be made by a qualified electrician in

compliance with all relevant codes. This

machine must be properly grounded to help

prevent electrical shock and possible fatal

injury.

A power plug is not provided with the Model 66.

You may either connect the proper UL/CSA

listed plug or “hardwire” the machine directly to

your electrical panel provided there is a

disconnect near the machine for the operator.

Consult electrical drawings on pages 33-36 for

further clarification of wiring setup.

This machine must be grounded. Grounding

provides a path of least resistance to help divert

current away from the operator in case of

electrical malfunction.

Figure 9

Figure 10

Recommended Gauges (AWG) of Extension Cords

Extension Cord Length *

Amps

25

feet

50

feet

75

feet

100

feet

150

feet

200

feet

< 5 16 16 16 14 12 12

5 to 8 16 16 14 12 10 NR

8 to 12 14 14 12 10 NR NR

12 to 15 12 12 10 10 NR NR

15 to 20 10 10 10 NR NR NR

21 to 30 10 NR NR NR NR NR

*based on limiting the line voltage drop to 5V at 150% of the

rated amperes.

NR: Not Recommended.

Figure 11

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comments to this Manuals

No comments