Powermatic Saw PWBS14 User Manual download pdf (Page 13)

9. Loosen the nuts on the four motor mounting

bolts (Fig. 4), and tension the v-belt by

pushing down on the motor. Tighten the four

motor mounting nuts.

The v-belt is properly tensioned when finger

pressure between the two pulleys causes

approximately 1/2" deflection (Fig. 4a).

10. Screw the two small knobs (Fig. 5) into the

threaded holes in the saw body. Slide the

pulley cover down over the knobs, and tighten

the knobs.

11. Attach trunnion support to saw body with two

M8 x 30 hex cap screws and two M8 lock

washers (A, Fig. 6).

12. Thread nut (B, Fig. 6) onto table stop bolt (C,

Fig. 6) and attach to trunnion support as

shown.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Powermatic Saw PWBS14 User Manual Page 13