Powermatic Saw PWBS14 User Manual download pdf (Page 16)

16

23. Install blade tension lever (Fig. 11a) and

tighten the set screws, using a 3mm hex

wrench. The movement of the blade tension

lever is explained under “Changing Blades”.

24. Mount the two miter gauge hooks (A, Fig. 12)

to the side of the stand with two M8 x 16

carriage bolts and two flanged hex nuts.

When not in use, the miter gauge can be

placed in these hooks (see “Miter Gauge”,

page 23).

25. Mount the blade hook (C, Fig. 12) with two M4

x 10 pan head screws as shown. The blade

hook will hold a rolled-up spare blade.

26. Mount the two fence hooks (B, Fig. 12) to the

opposite side of the stand with two M8 x 16

carriage bolts and two flanged hex nuts.

When not in use, the rip fence can be placed

in these hooks.

27. Transportation and handling may have

caused some fasteners to loosen. Before

operating, check all screws, bolts, and nuts to

make sure they are snug. Operate machine

only after reading the entire manual including

blade tracking, blade guide adjustments, and

safety rules.

Mounting Rails & Rip Fence

1. Disconnect machine from power source.

2. Mount rear rail (A, Fig. 13) to the band saw

table using two M6 x 20 hex cap screws, two

1/4" lock washers and two 1/4" flat washers

(B, Fig. 13). Do not tighten yet.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments