Powermatic Saw PWBS14 User Manual download pdf (Page 19)

14. For resawing operations attach the resaw

guide (Fig. 20) to the fence with the knob.

There is a slotted hole in the fence that will

accomodate the resaw kit. Position the resaw

guide so that it is centered with the front edge

of the saw blade. The resaw guide will give

you a taller, single-point contact surface

during resawing.

Tilting the Table

WARNING

Unplug the machine from the power

source before making any repair or adjustment!

Failure to comply may cause serious injury!

1. Loosen the two lock knobs (A, Fig. 21).

2. Tilt table up to 45 degrees to the right. The

angle is indicated on the trunnion scale.

3. Tighten the two lock knobs (A, Fig. 21).

Adjusting 90°

°°

° Table Stop

1. Disconnect machine from power source.

2. Loosen lock knobs (A, Fig. 21) and tilt table to

the left until it rests against the table stop (B,

Fig. 21).

3. Use a square placed on the table and against

the blade, as pictured in Fig. 22, to see if the

table is 90 degrees to the blade.

4. If an adjustment is necessary, tilt the table out

of the way and tighten the lock knobs (A, Fig.

21).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

No comments

Powermatic Saw PWBS14 User Manual Page 19