Powermatic TS29 User Manual download pdf (Page 13)

FIGURE 19

MITRE GAUGE & CLAMP

Mount mitre gauge and clamp to the sliding table as

follows (Figure 19):

1. Insert post (A) of the clamp assembly down

through hole (B) of the mitre gauge body (C), and thread

post (A) into hole (D) of sliding table.

2. Insert shaft of locking handle (E) down through

opening (F) of mitre gauge and thread shaft into hole

(G) of sliding table.

3. The clamp (H), shown in Figure 20, is supplied

with the mitre gauge to securely hold the workpiece

when shaping small pieces across the grain. The

clamp should be mounted as shown, and can be ad-

justed by loosening the screws (J).

MITRE FENCE

1. Slide the mitre fence (A) on to the two square

nuts (B) that are attached to the threaded part of the

locking levers (C). See Figure 21.

2. To slide mitre fence (A) to the left or right, loosen

locking levers (C), slide fence (A) to the desired posi-

tion and tighten locking levers (C). To change the angle

of the fence loosen locking handle (D). A scale (E) is

provided to indicate the mitre angle of the fence.

3. Loosen locking screw (I) and insert nut (J) of stock

stop assembly into channel on end of fence as shown.

See Figure 22.

4. Slide workstop (K) to desired position on fence

and tighten locking screw (I), as shown in Figure 23.

FIGURE 20

FIGURE 23

FIGURE 21

FIGURE 22

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

No comments

Powermatic TS29 User Manual Page 13